when i change the water height level it just goes back to the same level! Any help here? My map height is 8.5, I changed the water height to 7.9, and then when I hit "OK" it just snaps back to level 9. WTF?
See my image - if it says anything other than Default on your window, click Default then try again.
States are used to set multiple height values (and other settings) in a single water type, then you can use triggers to toggle between states. For doing things like making lava rise, or draining a flooded room.
By default it should look like my example, but if you clicked Add without realizing it you may be modifying an alternate state.
when i change the water height level it just goes back to the same level! Any help here? My map height is 8.5, I changed the water height to 7.9, and then when I hit "OK" it just snaps back to level 9. WTF?
I'm assuming your water height cannot be lower than your actual map height, perhaps?
Try raising it and playing around with it more? Does the same bug occur if you change it to, say, 12?
Do you have an alternate state set by chance?
If so, that would explain it. Make sure you're modifying the Default state, or the editor will snap back to it as soon as you close the window.
@Mozared: Go It snaps no matter what I do. It's starting to annoy me.
@Telthalion: Go
Whats a state? I'm simply changing the top slider thingo down and up, yet it keeps going back to normal. Oh, btw, I'm using shakuras water.
@ScrinKing: Go
See my image - if it says anything other than Default on your window, click Default then try again.
States are used to set multiple height values (and other settings) in a single water type, then you can use triggers to toggle between states. For doing things like making lava rise, or draining a flooded room.
By default it should look like my example, but if you clicked Add without realizing it you may be modifying an alternate state.
Mine's on default.
Hmmm...
That was my only idea. Not sure what else could be causing it, I've never had my water do that.
Have you tried closing/restarting the editor?
If I come across another possible solution I'll post it here, but I'm not too optimistic.