Hi, so I have a medivac. I want to make it so when I unload a unit from the medivac in a certain region, the unit immediately goes back inside the medivac.
All the triggers I have tried havn't worked. If anyone can help me with this problem it would be much appreciated! Thanks.
I looked at your map, but you seem to have ability commands that are simply not in my list of ability commands. I simply cannot order a warp prism or medivac to load units, because the ability commands simply aren't there. In fact, for some reason your ability command list is a lot smaller than the one I get.
Never mind, I discovered that double clicking parts of the action in the panel below the trigger panel allows you to select "Order: Order Targeting Unit".
Hi, so I have a medivac. I want to make it so when I unload a unit from the medivac in a certain region, the unit immediately goes back inside the medivac. All the triggers I have tried havn't worked. If anyone can help me with this problem it would be much appreciated! Thanks.
Please see my attached map and picture of the triggers.
If your goal is to deny unloading in the region however, you might want to consider disabling the unload ability.
I looked at your map, but you seem to have ability commands that are simply not in my list of ability commands. I simply cannot order a warp prism or medivac to load units, because the ability commands simply aren't there. In fact, for some reason your ability command list is a lot smaller than the one I get.
Any clue what could cause this?
@DysprosiumDy: Go
Did you try double-clicking the part that says "Order: Order With No Target"? ;)
You could also click the parenthesis around the ability command.
Never mind, I discovered that double clicking parts of the action in the panel below the trigger panel allows you to select "Order: Order Targeting Unit".
Hah, thanks for the quick reply though! :D