Ok Trigger works for Players but not the A.I cant figure out what needs to go in after to re initiate there attack or even get them to go to the trigger area. The trigger is set up as a portal area that will drop you down to a lower region on the map Players can click on it and will be sent down with out an issue and can use the return pad at the lower end to get back to the top the Trigger code set is as follows.
Event:
Unit - Any unit enters (Region) out 1-2
Actions Unit- Move triggering Unit Instantly to (Point) Drop Point 1-2
Unit- Order Triggering Unit to Stop (Replace existing orders)
I had to put the stop command in to stop the units from running back to the return pad I have tried moving my region out a bit but they always want to run back up even the users units were doing this. However the A.I will scout around the Out region but never go on it and if it does they will stand at the Lower drop point and not do anything. How do I get the A.I to go to the Out region as well as re initiate there attack sequence.
Rollback Post to RevisionRollBack
To post a comment, please login or register a new account.
Ok Trigger works for Players but not the A.I cant figure out what needs to go in after to re initiate there attack or even get them to go to the trigger area. The trigger is set up as a portal area that will drop you down to a lower region on the map Players can click on it and will be sent down with out an issue and can use the return pad at the lower end to get back to the top the Trigger code set is as follows.
Event: Unit - Any unit enters (Region) out 1-2
Actions Unit- Move triggering Unit Instantly to (Point) Drop Point 1-2 Unit- Order Triggering Unit to Stop (Replace existing orders)
I had to put the stop command in to stop the units from running back to the return pad I have tried moving my region out a bit but they always want to run back up even the users units were doing this. However the A.I will scout around the Out region but never go on it and if it does they will stand at the Lower drop point and not do anything. How do I get the A.I to go to the Out region as well as re initiate there attack sequence.